This is usually caused by setting the "wired connection" first and not the "wireless connection" first.

If you are not that set up "wireless connection" first and then set up the "wired connection" ，but are that connect the server to the router (or switch) first, and then get the wired connection IP address through "Quick installation tools", then you may get a wired connection IP address, such as IP: 192.168.1.4 (or similar). However, after obtaining the IP, the server system will automatically change the IP to 192.168.1.188 (or similar). At this time, the previous 192.168.1.4 will be invalid, and only the IP 192.168.1.188 automatically corrected by the later system will be available.

Therefore, in order to avoid trouble, please set the "wireless connection" of the server first, and then set the "wired connection"

If you accidentally make the wrong setting, please insert into the "RST" hole by the needle (or similar object) , long press for 5 ~ 10 seconds, and release when the "sys" light flashes, the server will return to the factory settings. You can make the correct settings again on the server.

Thank you.